China splicing hardware Manufacturers Factory Suppliers

This type Compression Terminal Clamps for Double Wire are applicable to connect copper conductor with aluminum terminal of electric device, qualified for good electric contact performance suitable

Oval Copper Crimp Sleeve(oil plugging) are suitable for the connection of copper conductors (section 16-500mm2) in power cable with electronic equiment.

Copper parallel groove clamps are contact fittings that connect wires in parallel to transfer electrical loads. They are widely used, such as jumpers for non-straight poles and towers, T-wiring at

The copper C clamp is normally used for connecting of copper wires.

The Compression Type Jumper Connector is jumper connection accessory between two busbars in power transmission facility.

Down lead clamp is used to lead cable down from the tower or pole in order to protect the cable from wear with tower or pole.Down lead is mainly used for ADSS and OPGW fixture in tower on cable fixed

The copper-aluminium bimetallic cable lugs are suitable for transition connection of the circular aluminium wires, hemicycle-sector aluminum wires, power supply cables in the distribution equipment

Aluminum Parallel groove clamp is mainly used for composite ground wire(OPGW) cable or the safety of the earth wire grounding to improve the reliability of the grounding system.

Bolted Cable Lug does not need a hydraulic tool but a spanner to finish installation. The special design ensures perfect strength and electric conductivity.

The terminal connector is generally used to connect terminal outgoing lines of busbar downlead and electrical equipment(Such as transformer,breaker,mutual inductor,disconnecting switch and wall

The splicing sleeves for ACSR are used for splicing or repairing of aerial conductor and ground wire of transmission line.

The outer splicing of mid span joint is aluminium,the inner sleeve is hot-dip galvanized steel.