China splicing seal Manufacturers Factory Suppliers

There is no need to remove the insulator skin of cable to make the cable branch.The main cable do not need to be cut down,the branch can be made at any place of the cable as the joint is completely

Compression H tap connector is used for non-load-bearing connection and branching of conductors in overhead lines. The product can be equipped with an optional insulation cover for protective

The Bolted Type C Connector is made of high strength alloy of elasticity with good electrical conductivity and according to different specifications of wires, it is designed with a specific shape of

The c copper connector has the advantages of simple construction, small occupation area, long service life, no environmental pollution and low resistance value,etc..

Copper parallel groove clamp is used in the connecting of copper conductors.

JBTL series bimetal parallel groove clamp is suitable for unendurable force splicing and branch of the aerial wire. It has the function of protection and insulation when it matches insulating sheth.

Our PG clamps are divided into: Aluminium PG clamp, Copper PG clamp, Bimetallic PG clamp. The parallel groove clamp is suitalbe for unendure force splicing and branch on the aerial wire, being used

The J type pg clamp belongs to shaped parallel groove clamp.The parallel groove clamp is used to connection of AAC or ACSR of small and medium-sized section and steel strand of overhead lightning

The galvanized guy clamp is used for connecting or branching steel wires.

The bimetallic Al-Cu parallel groove clamp is a widely used contact fitting to transfer electric load and parallel wires.The splicing of jumper wire for non-linear tower,branch

Aerial insulation aluminium conductor and insulation aluminium cover are being used together action is insulation protection .

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.