China Lashing Wire Clamp Manufacturers Factory Suppliers

Lashing Wire rope Clamp is used for telco and CATV aerial plant to terminate and hold the end of the lashing wire, either at an interruption in continuity or at the end of the lashing wire coil.

This is zinc plated triple forged wire rope clamp.

The NUT Wedge Clamp consists of a body of hot-dip galvanized malleable iron,  wedges and hot-dip galvanized steel component.

Stay Wire Clamp is used for telco and CATV aerial plant to terminate and hold the end of the lashing wire, either at an interruption in continuity or at the end of the lashing wire coil.

The cross joint is used to fix the wire on pole.Good electrical conductivity.

The wire rope clip is hot-dip galvanized, it is used to fix the steel wire rope.

The Wire Rope Clamp body is malleable iron and the other parts are hot-dip galvanized steel.

The clip body of Wire Rope Clamp is malleable iron and the other parts are zinc plating coloring steel.

The Thimble Clevis is mainly used to connect the preformed rod tension clamp with other linking fittings.

The stay rod is used to fix the pole so that it does not fall to one side. Usually one or two stay rods are installed on a pole.

The U channel steel is a strip shape rolled steel with groove shape section.It is a kind of carbon structural steel for construction and mechanical use and a profiled steel with complex sections,of

The stay rod is used for installation of galvanized iron wire strands as well as fixture of overhead ground wire and guy grip on guy-strained tower; it makes use of arm force subjected to the wedge