China fitting splicing slot Manufacturers Factory Suppliers

Watertight mould for tapping services or mains with insulation piercing (FT) with 1 or 2 taps.This mould is to be used with our simultaneous tightening connectors type TTD as can use for separate tap

Our PG clamps are divided into: Aluminium PG clamp, Copper PG clamp, Bimetallic PG clamp.

The copper C clamp is normally used for connecting of copper wires.

Circuit Breaker Universal Clamp is mainly suitable for connecting wires to the incoming and outgoing terminals of electrical equipment (such as circuit breakers, isolating switches, fuses, load

Down lead clamp is used to lead cable down from the tower or pole in order to protect the cable from wear with tower or pole.Down lead is mainly used for ADSS and OPGW fixture in tower on cable fixed

The copper cable terminal is an appliance that connects the copper terminal and the wire with a special crimping pliers at the end of the wire in order to ensure reliable and convenient wiring in the

Copper parallel groove clamp is used in the connecting of copper conductors.

Waterproof Piercing Clamp are mainly composed of insulating shell, piercing blade, waterproof rubber pad, and torque bolt.

Our PG clamps are divided into: Aluminium PG clamp, Copper PG clamp, Bimetallic PG clamp. The parallel groove clamp is suitalbe for unendure force splicing and branch on the aerial wire, being used

The J type pg clamp belongs to shaped parallel groove clamp.The parallel groove clamp is used to connection of AAC or ACSR of small and medium-sized section and steel strand of overhead lightning

The bimetallic Al-Cu parallel groove clamp is a widely used contact fitting to transfer electric load and parallel wires.The splicing of jumper wire for non-linear tower,branch

The Aluminium Compression Tap Connector is generally used in connection of jumper wires,branch lines,lead wires,service mains and other wires on the tower in overhead high-voltage and low-voltage