Hot-dip Galvanized Suspension Clamp

Measures:

Measures for overhead lightning wire drop caused by wear of suspension clamp

1.The hanging plate on the hanging shaft of the hull of the suspension clamp is fixed by a pin with a flat gasket inside which covers the connecting part of the hanging shaft.It is difficult to find the wear of the hanging shaft of the hull without opening the gasket. Therefore, when checking the wear degree of the hanging shaft, the pin must be removed to open the gasket.The temporary measures to prevent the lightning conductor from falling should also be paid attention to in the inspection at the same time.

2.In the ordinary line maintenance work, especially the annual inspection of the line, overhaul should be carried out strictly according to the rules and regulations, and all kinds of suspension clamps should be opened for inspection according to the provisions.

3.The check for suspension clamp in line maintenance work is often ignored , at the same time of The construction technology and material selection should be strengthened and the ordinary maintenance should be strengthened at the same time, The record should be set for section of suspension clamp where wear is easily happening to shorten the clamp inspection cycle. The daily patrol inspection programs for suspension clamp should be increased.

Hot Tags: hot-dip galvanized suspension clamp, China, manufacturers, suppliers, factory, customized, Galvanized Suspension Clamp, Angle Type Suspension Clamp, Suspension Clamp In Power Accessories, Suspension Clamp With Clevis, ODM Insulated Suspension Clamp, Suspension Clamp For Power Line