China splicing washer Manufacturers Factory Suppliers

Insulation piercing connector is mainly suitable for the connection of the overhead insulation conductor, branch connection and grounding protection, It is used for the voltage which is 20KV, 10KV

Hydraulic Jumper Connectors are used to bridge two electrical components in a circuit, thereby providing a continuous flow of current. They are designed to withstand high voltage and current loads,

Our PG clamps are divided into: Aluminium PG clamp, Copper PG clamp, Bimetallic PG clamp.

The Bolted Type C Connector is made of high strength alloy of elasticity with good electrical conductivity and according to different specifications of wires, it is designed with a specific shape of

The PG clamp body and keepers are aluminium alloy, the other parts are hot-dip galvanized steel.

Down lead clamp is used to lead cable down from the tower or pole in order to protect the cable from wear with tower or pole.Down lead is mainly used for ADSS and OPGW fixture in tower on cable fixed

Watertight mould for tapping services or mains with insulation piercing (FT) with 1 or 2 taps.This mould is to be used with our simultaneous tightening connectors type TTD as can use for separate tap

When the distribution overhead line is aluminum wire, and the lead wire is copper wire, it is Use a copper-aluminum parallel groove clamp, because the direct connection of copper-aluminum will cause

The insulated piercing clamp is composed of reinforced shell,piercing blade,sealed plate,waterproof silicone grease, high strength bolt, torque nut and cable terminal cap cover.

The splicing sleeves for ACSR are used for splicing or repairing of aerial conductor and ground wire of transmission line.

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.

The bimetallic parallel goroove clamps are designed to connect aluminumconductors and copper condcutors.Advanced forging technology enhances the mechanical strength of the clamp.