China pipe splicing end Manufacturers Factory Suppliers

The copper cable terminal is an appliance that connects the copper terminal and the wire with a special crimping pliers at the end of the wire in order to ensure reliable and convenient wiring in the

Bimetallic Bolted Mid Span Joint is mainly used for splicing connections between insulated wires, aluminum stranded wires, aluminum alloy stranded wires, and steel-cored aluminum stranded wires at

-The Mechanical connectors can accommodate ACSR conductors over armor rod within the diameter range indicated-Application over armor rod-Used for all Combinations of copper, aluminum, ACSR, AAAC and

The C type connector belongs to the field of non-load-bearing connectors in the power network, and is particularly suitable for the connection of the branch wires of the main line and the sub-line in

The Compression Repair Sleeve is used to renovate the harmed conductor as connection fitting of resuming the latter's electric & mechanical performance.

The Adjustable PG Clamp is used to connect two parallel bare conductors.And the conductors can be aluminium alloy or aluminium steel reinforced and copper conductor.

This tape fixing clamp is used to tightly connect the wire and the rod together.

This series insulation piercing clamp is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

The J type pg clamp belongs to shaped parallel groove clamp.The parallel groove clamp is used to connection of AAC or ACSR of small and medium-sized section and steel strand of overhead lightning

The splicing sleeves for ACSR are used for splicing or repairing of aerial conductor and ground wire of transmission line.

The outer splicing of mid span joint is aluminium,the inner sleeve is hot-dip galvanized steel.

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.