China pipe splicing device Manufacturers Factory Suppliers

CTO Type Aluminum Cable Connector is suitable for branching identical cross-sections and no need to split the main conductor.

Hydraulic Jumper Connectors are used to bridge two electrical components in a circuit, thereby providing a continuous flow of current. They are designed to withstand high voltage and current loads,

Oval Copper Crimp Sleeve(oil plugging) are suitable for the connection of copper conductors (section 16-500mm2) in power cable with electronic equiment.

The Compression Repair Sleeve is used to renovate the harmed conductor as connection fitting of resuming the latter's electric & mechanical performance.

The Adjustable PG Clamp is used to connect two parallel bare conductors.And the conductors can be aluminium alloy or aluminium steel reinforced and copper conductor.

Earthing PG Clamp is suitable for grounding connections and high-voltage line discharge connections in overhead insulated lines of 20kV and below. Earthing PG Clamp is used in conjunction with the

The c copper connector has the advantages of simple construction, small occupation area, long service life, no environmental pollution and low resistance value,etc..

Bolted Cable Lug does not need a hydraulic tool but a spanner to finish installation. The special design ensures perfect strength and electric conductivity.

The C-type clamps are mainly used for 20KV overhead insulated conductors, aluminum stranded wires, steel-cored aluminum stranded wires, steel stranded wires and copper wires in non-stressed positions

The galvanized guy clamp is used for connecting or branching steel wires.

AS a splicing fitting,the parallel groove clamp for transmission power line is suitable for unending force splicing and branch on the aerial wire,being used with insulation cover.Its action is

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.