China ODM Mid Span Sleeve Manufacturers Factory Suppliers

Copper Connecting Tube adopts tin plating process, which has good electrical conductivity and connects wires and electrical equipment in power distribution devices.

Bimetallic Bolted Mid Span Joint is mainly used for splicing connections between insulated wires, aluminum stranded wires, aluminum alloy stranded wires, and steel-cored aluminum stranded wires at

Hydraulic Jumper Connectors are used to bridge two electrical components in a circuit, thereby providing a continuous flow of current. They are designed to withstand high voltage and current loads,

Oval Copper Crimp Sleeve(oil plugging) are suitable for the connection of copper conductors (section 16-500mm2) in power cable with electronic equiment.

Copper parallel groove clamps are contact fittings that connect wires in parallel to transfer electrical loads. They are widely used, such as jumpers for non-straight poles and towers, T-wiring at

The Compression Repair Sleeve is used to renovate the harmed conductor as connection fitting of resuming the latter's electric & mechanical performance.

The Compression Type Jumper Connector is jumper connection accessory between two busbars in power transmission facility.

Watertight mould for tapping services or mains with insulation piercing (FT) with 1 or 2 taps.This mould is to be used with our simultaneous tightening connectors type TTD as can use for separate tap

Repair sleeves play an important role in maintaining the integrity of power transmission lines. These sleeves are used to repair a damaged section of a power line, preventing the need for costly and

The splicing sleeves for ACSR are used for splicing or repairing of aerial conductor and ground wire of transmission line.

The outer splicing of mid span joint is aluminium,the inner sleeve is hot-dip galvanized steel.

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.