China Wedge Dead End Clamp Manufacturers Factory Suppliers

This series of Wedge dead end Clamp has the advantages of convenient use, good energy saving effect, small damage to the wire, reasonable structure and stable performance.

This series of Wedge Tension Clamp has the advantages of convenient use, good energy saving effect, small damage to the wire, reasonable structure and stable performance.

The strain clamp body and keepers are malleable iron, the cotter-pin is stainless steel, the other parts are hot-DIP galvanized steel. This type strain clamp is customized for exporting.

This Strain Clamp is usually used in low-voltage lines, has good conductive wire performance, and is easy to install. The minimum tensile strength is not less than 40KN.

The Self-locking Dead End Clamp is a fitting used to fix conductor to bear the conductor tensile force and hing the conductor to tension clamp set or pole to tower.It can be divided into two types

The tension clamp is a power fitting fixing conductor to bearing the conductor tension and hanging the conductor with tension set or pole tower.This type is parallel tension clamp.

The wedge type tension clamp is mainly composed of clamp body,thread clamp piece and rod.The conductor is placed in the clamp body wrapped by thread clamp piece.The clamp body tightly hold the

The bolt quantity of dead end clamp can be adjusted by your requirements.The body and keepers of the dead end clamp are aluminum alloy, the cotter-pin is stainless steel and the other parts are

The wedges make it clamped.Special fibre glass reinforced plastic and aluminum alloy body could resist weather.

The cotter pin of the wedge type strain clamp is stainless steel and the other parts are steel.All ferrous parts are hot-dip galvanized.

The wedge strain clamp body and wedge are malleable iron or steel according to required breaking load. All ferrous parts are hot-dip galvanized and steel except the stainless steel cotter-pin.

The low voltage Insulator spindle is forged in one piece from basic open hearth steel and provided with a square wrenching shoulder. These insulator spindle have a 1 inch ANSI standard cast lead