China splicing bolt Manufacturers Factory Suppliers

This tape fixing clamp is used to tightly connect the wire and the rod together.

Hydraulic Jumper Connectors are used to bridge two electrical components in a circuit, thereby providing a continuous flow of current. They are designed to withstand high voltage and current loads,

Description: Insulation Piercing Connector is suitable for aluminum and copper conductors and componentsnot losable, end cap attached to body, Insulation material made of weather resistant glass

The c copper connector has the advantages of simple construction, small occupation area, long service life, no environmental pollution and low resistance value,etc..

Copper Connecting Tube adopts tin plating process, which has good electrical conductivity and connects wires and electrical equipment in power distribution devices.

The copper-aluminium bimetallic cable lugs are suitable for transition connection of the circular aluminium wires, hemicycle-sector aluminum wires, power supply cables in the distribution equipment

Aluminum Parallel groove clamp is mainly used for composite ground wire(OPGW) cable or the safety of the earth wire grounding to improve the reliability of the grounding system.

The J type pg clamp belongs to shaped parallel groove clamp.The parallel groove clamp is used to connection of AAC or ACSR of small and medium-sized section and steel strand of overhead lightning

This series insulation piercing connector is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

The bimetallic Al-Cu parallel groove clamp is a widely used contact fitting to transfer electric load and parallel wires.The splicing of jumper wire for non-linear tower,branch

Aerial insulation aluminium conductor and insulation aluminium cover are being used together action is insulation protection .

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.