China pipe splicing duct Manufacturers Factory Suppliers

This series insulation piercing clamp is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

Hydraulic Jumper Connectors are used to bridge two electrical components in a circuit, thereby providing a continuous flow of current. They are designed to withstand high voltage and current loads,

Description: Insulation Piercing Connector is suitable for aluminum and copper conductors and componentsnot losable, end cap attached to body, Insulation material made of weather resistant glass

The copper C clamp is normally used for connecting of copper wires.

The Down Leading clamp is uswd to fix the cable to splice pole/tower and terminal pole/tower in the down-lead to the closure.

The lightning protection piercing connector is a product with a new structure. It is mainly installed on the load side of the line insulator. It has the protective function of preventing 10KV

The J type pg clamp belongs to shaped parallel groove clamp.The parallel groove clamp is used to connection of AAC or ACSR of small and medium-sized section and steel strand of overhead lightning

The galvanized guy clamp is used for connecting or branching steel wires.

This type Compression Terminal Clamps for Double Wire are applicable to connect copper conductor with aluminum terminal of electric device, qualified for good electric contact performance suitable

This series insulation piercing connector is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

The bimetallic Al-Cu parallel groove clamp is a widely used contact fitting to transfer electric load and parallel wires.The splicing of jumper wire for non-linear tower,branch

H-type connectors are generally used in the crimp connection of jumpers, branch wires, lead wires, household wires, and house wires of overhead high-voltage and low-voltage power line towers.