China ODM Galvanized Down Lead Clamp Manufacturers Factory Suppliers

Down lead clamp is used to lead cable down from the tower or pole in order to protect the cable from wear with tower or pole.Down lead is mainly used for ADSS and OPGW fixture in tower on cable fixed

Bimetallic Bolted Mid Span Joint is mainly used for splicing connections between insulated wires, aluminum stranded wires, aluminum alloy stranded wires, and steel-cored aluminum stranded wires at

The C type connector belongs to the field of non-load-bearing connectors in the power network, and is particularly suitable for the connection of the branch wires of the main line and the sub-line in

The copper C clamp is normally used for connecting of copper wires.

The Compression Repair Sleeve is used to renovate the harmed conductor as connection fitting of resuming the latter's electric & mechanical performance.

The Down Leading clamp is uswd to fix the cable to splice pole/tower and terminal pole/tower in the down-lead to the closure.

Watertight mould for tapping services or mains with insulation piercing (FT) with 1 or 2 taps.This mould is to be used with our simultaneous tightening connectors type TTD as can use for separate tap

This series insulation piercing clamp is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

Repair sleeves play an important role in maintaining the integrity of power transmission lines. These sleeves are used to repair a damaged section of a power line, preventing the need for costly and

This series insulation piercing connector is mainly used for wire branching The applicable voltage is 10kV, 1kV and less more than 1kV.

The bimetallic Al-Cu parallel groove clamp is a widely used contact fitting to transfer electric load and parallel wires.The splicing of jumper wire for non-linear tower,branch

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.