China heavyweight tension clamp Manufacturers Factory Suppliers

The series of wedge strain clamp are mainly used in the voltage rating of 1KV and below power insulated line.

The tension clamp is suitable for aerial line up to 220kV, fixing aluminium wire or steel core aluminium wire on the strain pole.

The insulated tension clamps are used to anchor and tighten LV-ABC lines with insulated neutral messenger

It is a kind of overhead power accessories and it's used to terminate 4-core of aerial bundle conductor. Its function is fixing and tightening the insulation conductor. The advantage of it is easy

The anchoring clamps are desgined for service line with 2 or 4 conductors.

The strain clamp body and keepers are malleable iron, the cotter-pin is stainless steel, the other parts are hot-DIP galvanized steel. This type strain clamp is customized for exporting.

The anchoring fitting,is also known as tension clamp or fastened fitting,which is mainly used to fasten the terminal of wires to make it fixed in the tensile insulator string and anchor terminal of

This Strain Clamp is usually used in low-voltage lines, has good conductive wire performance, and is easy to install. The minimum tensile strength is not less than 40KN.

The tension clamp is a power fitting fixing conductor to bearing the conductor tension and hanging the conductor with tension set or pole tower.This type is parallel tension clamp.

This new type tension clamp is composed of wedge-shaped holder and wedge-shaped clamp fit the shape of the inner hole in the holder set in the clamp body and lining sleeve.

The wedge clamping mechanism directly hold the insulated wire without peeling wire insulation layer when installing.

The compression dead end clamp is used to fix and connect conductor onto the tension insulator string or the fittings on pole and tower through sustaining tensile force generated by the conductor.