China flexible tension clamp Manufacturers Factory Suppliers

The tension clamp is suitable for aerial line up to 220kV, fixing aluminium wire or steel core aluminium wire on the strain pole.

The dead end clamps are used to anchor and tighten LV-ABC lines with insulated neutral messenger. These Clamps are easy to install with tools and suitable for various climatic conditions.

Tension clamp refers to the hardware used to fix the wire to bear the tension of the wire and hang the wire to the tension string or tower.

The Gun Type Strain Clamp body and keepers are malleable iron, the cotter-pin is stainless steel, the other parts are hot-DIP galvanized steel. This type tension clamp is customized for exporting.

A type of wire clamp, which is widely used to support telephone drop wire at span clamps, drive hooks and various drop attachments.

THA anchoring clamp is used to fix 2 or 4 core typically between the pole and the fascia board. The unique design of plastic clamp enables the cable direction to be a 90 degree opposite configuration

This Strain Clamp is usually used in low-voltage lines, has good conductive wire performance, and is easy to install. The minimum tensile strength is not less than 40KN.

The tension clamp is a power fitting fixing conductor to bearing the conductor tension and hanging the conductor with tension set or pole tower.This type is parallel tension clamp.

The wedge type tension clamp is mainly composed of clamp body,thread clamp piece and rod.The conductor is placed in the clamp body wrapped by thread clamp piece.The clamp body tightly hold the

which are insulating protective fittings to fix aluminum wire or steel core aluminum wire on the strain pole and used in aerial insulation aluminum conductor and insulation aluminum cover.

The wedge clamping mechanism directly hold the insulated wire without peeling wire insulation layer when installing.

The clamp is composed of a body, wedges and removable and adjustable bail or pad.