China fitting splicing kit Manufacturers Factory Suppliers

There is no need to remove the insulator skin of cable to make the cable branch.The main cable do not need to be cut down,the branch can be made at any place of the cable as the joint is completely

The Compression Type Jumper Connector is jumper connection accessory between two busbars in power transmission facility.

Circuit Breaker Universal Clamp is mainly suitable for connecting wires to the incoming and outgoing terminals of electrical equipment (such as circuit breakers, isolating switches, fuses, load

Waterproof Piercing Clamp are mainly composed of insulating shell, piercing blade, waterproof rubber pad, and torque bolt.

When the distribution overhead line is aluminum wire, and the lead wire is copper wire, it is Use a copper-aluminum parallel groove clamp, because the direct connection of copper-aluminum will cause

Our PG clamps are divided into: Aluminium PG clamp, Copper PG clamp, Bimetallic PG clamp. The parallel groove clamp is suitalbe for unendure force splicing and branch on the aerial wire, being used

The Bimetallic PG Clamp is applied for non-bearing connection of conduction and branch,which is usually used with insulating cover to play a role of insulating and protecting.

The C-type clamps are mainly used for 20KV overhead insulated conductors, aluminum stranded wires, steel-cored aluminum stranded wires, steel stranded wires and copper wires in non-stressed positions

Copper-aluminium PG clamp is used for the Non-bearing connection and offset of aluminium stranded wire,copper core aluminium stranded wire,copper brand wire.

The outer splicing of mid span joint is aluminium,the inner sleeve is hot-dip galvanized steel.

Under the rated voltage,the splicing point temperature should not higher than the conductor temperature when through the max load electric current for long time.

The Aluminium Compression Tap Connector is generally used in connection of jumper wires,branch lines,lead wires,service mains and other wires on the tower in overhead high-voltage and low-voltage